3D Project (Product Design) series 2016 - "Building Machines for object engineering Season 2" by "StAlMaGiC DeSiGn" workshop
1. Normal boiler with cast base plate! ---------------------------------------------------- The coat consists of a sleeve, of a certain cross-section with wedges holding ropes, molded base plates with a conical hole, a spring, a plastic extension, a metal ribbed tube, and a bundle of ropes. This type is a smaller base of than a metal plate base. 2. Normal boiler with metal plate! ----------------------------------------------- The coil consists of a sleeve of a certain cross-section with ropes that hold ropes, metallic base plates with conical funnel, springs, metal ribbed tubes and a rope sheave. 3. ADJUSTING SQUARE S-1/16! ------------------------------------------ The learning angle is used to extend the rope Ø 15.7 mm. It consists of a coupling, two sleeves with left and right thread, two springs and two bolts. Both ropes are pushed into the coupling through the springs, the pins to the stop and then the left and right sleeves are turned to the end. This is achieved by the extension of the rope that is pre-bridged in the construction structures...
http://stalvisualdesign.com/